How to solve the anti-interference problem of input liquid level transmitter
The input type liquid level transmitter has good stability, high precision and convenient installation and use. In daily use will be affected by many factors. In order to enable users to better use the input liquid level transmitter, to provide customers with solutions.
First of all, we all use the traditional method to solve the problem, but it has no good effect. For this traditional method, that is, when measuring the liquid level of a small water tank on the equipment, the pressure transmitter is installed at the bottom of the water tank, and the sensor line is good. But there is a problem, when there is water flowing down the water tank, it will make the pressure swing larger. From the data analysis, if you take out one data in one second, the swing is relatively large, and there is a correct value in it; It is not good to average a number in 10ms. So how to solve it?
Solutions to the anti-interference problem of input liquid level transmitter:
Avoid the direct impact of the pressure on the probe when the liquid flows down, or use other objects to block the pressure of the instant direct impact when the liquid flows down;
Install the water inlet into a shower type, cut off a large stream of water into a small stream of water and spray it down. The effect is good; Bend the inlet pipe to make the inlet slightly upward. When the water comes out, it will first throw into the air and then fall down, reducing the direct impact (converting kinetic energy into potential energy).
English
